Required Tools and Supplies
|T40 TORX® socket||5/8-Inch Spark Plug Socket|
|Air Chuck||Dielectric Grease|
|Safety Glasses||Nitrile Gloves|
To inspect and replace the spark plugs on your 2018 to 2022 RZR RS1, follow these steps:
1. Park the vehicle on a flat, level surface in a well-ventilated area and ensure it is in PARK.
2. Move to the left rear fender and disengage the two rubber straps and release the quarter-turn latch.
3. Disengage the retention tabs and pivot the panel out to remove.
4. Remove the engine access panel fastener with a T40 TORX® socket.
5. Slide the panel back to disengage its retention tabs and remove from the vehicle.
6. Before continuing, clean the area around the spark plug boots using a clean, dry cloth.
7. Carefully lift up to remove the spark plug boots.
8. Before continuing, blow any dirt or debris out of the spark plug wells with compressed air to prevent debris from falling into the cylinders.
9. Using a 5/8-inch spark plug socket, carefully loosen the spark plugs and remove from the vehicle. If reusing, take note of the cylinders they were installed in for reinstallation.
10. Inspect the electrodes for wear and carbon buildup and verify there are no cracks around the insulation. The spark plug should have a sharp outer edge with no rounding or erosion.
11. Inspect and adjust the spark plug gap if needed. The spark plug gap should measure 0.028-0.031 in (0.7-0.8 mm).
12. If necessary, replace with the recommended spark plug. Refer to your Owner's Manual for the recommended plugs. Severe engine damage may occur if the incorrect plug is used.
13. Install the spark plugs into the engine and torque to 7ft-lbs (10 Nm). Do not apply anti-seize to the threads.
14. Apply dielectric grease to the spark plug boots.
15. Reinstall the boots and press down to ensure they are fully seated. Spark plug wires are not interchangeable and are different lengths.
16. Reinstall the engine access panel ensuring the retention tabs in front are properly engaged and align the mounting hole.
17. Reinstall the panel fastener and torque the fastener to 8 ft-lbs (11 Nm).
18. The rear panel features three retention areas. One on the rear of the panel, another in the middle on the heat shield, and two additional tabs that engage with the lower rocker panel.
19. Engage the rear retention tab first and pivot the panel in to secure the remaining tabs.
20. Latch the two straps and secure the quarter-turn latch.
21. Start the engine to verify proper operation.
For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
YouTube® is a registered trademark of Google, Inc.
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.